Case Studies
How BoreJet nozzles solve real industrial duties, sized to the vessel, not guessed from a catalogue.
Case Study: Fine Mist Disinfection on a Beverage Bottle Filler
A European beverage bottling plant replaced flood bottle rinsing and soak baths with fixed point fine mist at the bottle, the closure and the filler valve. Peracetic acid solution fell from 6.0 to 1.2 mL per bottle, rinse water from 20 to 3.0 mL, and the log reduction on the bottle wall rose from 2.1 to 4.3. The sizing runs from the 24,000 bottle an hour line speed down to litres per hour per nozzle.
Sep 13, 2026
Case Study: Cutting Die Lubricant Use on a Hot Forging Press
A European closed-die forging plant replaced a manual air-assisted spray gun with external mix air atomizing nozzles on a timed injection. Lubricant fell from 90 to 45 mL per stroke, the cycle shortened from 10.0 to 9.4 s, and rejects for laps and sticking fell from 4.2 to 0.9 percent. The sizing runs from the target film depth to the millilitres per stroke, and it transfers to any hot forging press on an 8 to 12 s cycle.
Sep 12, 2026
Case Study: Descaling and Strip Cooling Headers in a Hot Strip Mill
A hot strip mill was fighting residual scale, uneven cooling across the strip width and a growing spread in coil properties. A header rebuild with matched nozzle families and angles, pressure set at the header, and replacement on a measured 10 percent flow rise brought all three under control. This account is anonymized and built on published industry practice ranges, not on a named customer.
Sep 10, 2026
Case Study: Cattle Fogging Retrofit for Fly Control on a 400-Head Feedlot
A feedlot in the US Great Plains retrofitted low-pressure misting lines along its feed bunk for premise fly control and heat relief. The system was sized from published fogging practice on droplet size, line pressure, and nozzle spacing. The client stays anonymized, and results are cited as published ranges, not site measurements.
Sep 7, 2026
Case Study: Spray Drying Scale-Up, Nozzle Choice From Pilot to Production
A food ingredient producer scaled a spray drying line from a small pilot rig to a production dryer and held the powder particle size target by scaling nozzle count rather than orifice size. The sizing logic transfers to any pressure atomised drying duty. The account is anonymized and built on published practice.
Sep 7, 2026
Case Study: Cutting CIP Cycle Time and Water Use on a Dairy Blending Tank
A European dairy processor replaced static spray balls with a compact rotary jet head on a 3.5 m blending tank. Cycle time and water use came down inside the published rotary-head ranges, and the dead zones behind the agitator baffles passed swabs without manual cleaning. The sizing logic transfers to any CIP tank.
Aug 28, 2026
Case Study: Evaporative Cooling for a Data Center Intake
A colocation facility precooled its air handling intake with high-pressure misting instead of adding compressor capacity. Droplet sizing, nozzle density and water quality carried the retrofit, with published ranges used as the acceptance band.
Aug 28, 2026
Case Study: Dry Fog Dust Suppression at a Bulk Material Transfer Point
A bulk handling operation replaced wet sprinklers with dry fog at a conveyor transfer point, cutting visible dust inside the published 80 to 95 percent range without wetting the product. The sizing logic transfers to any dry, moisture-sensitive material.
Aug 28, 2026